Warnings or Notices
- The BeyondFit mask is perfectly adapted for you, designed and manufactured from a 3D impression of your face. It is therefore not recommended to lend your BeyondFit mask to another person.
- Avoid leaving the BeyondFit Mask near a heat source.
- Improper use or storage of this product can cause health problems, personal injury or death. Keep out of reach of children.
- For information on the proper use of this product, refer to the instruction sheet or contact us.
- It is not recommended to wear the mask for more than eight consecutive hours.
- Do not use in environments containing less than 19.5% oxygen.
- Do not use in environments presenting an immediate danger to life or health.
- Do not exceed the maximum concentrations prescribed by the regulatory standard.
- Never replace, alter, add or remove parts. Use only appropriate replacement parts in accordance with the manufacturer's instructions.
- The mask and all parts are latex-free.
- This filter mask provides protection against some particulate contaminants without eliminating the risk of illness, infection or exposure to them.
- All approved respiratory protection devices must be selected, fitted, used and maintained in accordance with the procedures established by OSHA, CSA and other applicable regulations.
- The possibility of a 3D reading and proper fit of BeyondFit decreases with increasing facial hair for men.
The filters are disposable and can be worn for 8 consecutive hours.